Knee mill in great condition! Absolute unit of a machine! Low hours! Comes with: 6" Kurt vice Dividing Head Right Angle Spindle Attachment DRO Power Table Crossfeed T-Slot Clamping Kit 50" x 12" Table The head can tilt, nod, and retract in and out as well as swivel. It has spindle power feed. Uses R8 collet system and comes with a set of collets and a keyless chuck. It runs off of direct 3Ph power from the wall. Mill is currently setup and able to be ran for inspection. This setup new would run you $25k +shipping without all the extras Don't waste my time. If the listing is up, it's available. No trades. EMAIL ONLY! IF YOU LEAVE YOUR PHONE NUMBER, I WILL CALL YOU TO ANWSER ANY QUESTIONS.